If you intend to use the inlet ring then this procedure must be followed.
The body and inlet ring of SRS800 blower are made from PPS plastic.
PPS (Poly Phenylene Sulfide) is a high temperature material which withstands over 400
degree F while keeping its rigidity.
Not many adhesives adhere PPS well up to the material’s rated temperature.
Commonly available instant glues or Super Glues (Cyanoacrylates) deteriorate in strength
rapidly from fairly low temperatures. T
hese glues are not recommended for this application.
To insure high strength bonding when using the inlet ring as a load bearing mounting flange,
we suggest using Loctite 4210 adhesive & 770 Primer.
Before bonding, scuff surfaces well, clean and use Loctite SF770 primer. 
Loctite 4210 does not cure as quickly as the other instant glues and takes 24 hours for full cure.
Follow the directions for best results. T
his glue is not available at Lowe’s or other typical consumer outlets.
You can find it online or purchase from McMaster Carr.


Technical information    Installation arrangements, Pressure loss, Stone guard effects, etc.
The fan blade does not restrict
the flow at even 170mph.
High speed test was performed
on the rig with high pressure blower.
   
SRS800 Brake Cooling Blower developed by Suzuka Racing are widely used by NASCAR top teams.

   North America customer: Available from ProSystem Inc, of Charlotte, North Carolina Phone 704-799-8100
   --http://prosystembrakes.com--
   












 HOME
WIND TUNNEL SVC.
 CLAY MODEL
 RACE CAR
 TRUCK
 PRODUCTION CAR
 PRODUCTS
  WIND TUNNEL
 MOVING BELT
  ACTIVE WING
 BRAKE BLOWER
  CFD
 GALLERY
 PROFILE & CONTACT
               SUZUKA RACING SVC.
        ----Since 1980---